Nortel Networks WEB OS 212777 - Manual (Page 93)

Web OS 10.0 Application Guide
Chapter 4: OSPF n 93
212777-A, February 2002
Configuring OSPF for Host Routes on Web Switch #1
1. Configure basic SLB parameters.
Web switch 1 is connected to two real servers. Each real server is given an IP address and is
placed in the same real server group.
2. Configure client and server processing on specific ports.
3. Enable direct access mode.
4. Configure the primary virtual server.
Alteon Web Switch # 1 will be preferred for virtual server 10.10.10.1.
>> # /cfg/slb/real 1 (Select menu for real server 1)
>> Real server 1 # rip 100.100.100.25 (Set the IP address for real server 1)
>> Real server 1 # ena (Enable the real server)
>> Real server 1 # ../real 2 (Select menu for real server 2)
>> Real server 2 # rip 100.100.10.26 (Set the IP address for real server 2)
>> Real server 2 # ena (Enable the real server)
>> Real server 2 # ../group 1 (Select menu for real server group 1)
>> Real server group 1 # add 1 (Add real server 1 to group)
>> Real server group 1 # add 2 (Add real server 2 to group)
>> Real server group 1 # enable (Enable the group)
>> Real server group 1 # ../on (Turn SLB on)
>> Layer 4# port 4 (Select switch port 4)
>> SLB Port 4 # client ena (Enable client processing on Port 4)
>> SLB Port 4 # ../port 5 (Select switch Port 5)
>> SLB Port 5 # server ena (Enable server processing on Port 5)
>> Layer 4 Port 5# ../adv (Select the SLB advance menu)
>> Layer 4 Advanced# direct ena (Enable DAM)
>> Layer 4 Advanced# .. (Return to the SLB menu)
>> Layer 4 # virt 1 (Select menu for virtual server 1)
>> Virtual server 1 # vip 10.10.10.1 (Set the IP address for virtual server 1)
>> Virtual server 1 # ena (Enable the virtual server)
>> Virtual server 1 # service http (Select menu for service on virtual server)
>> Virtual server 1 http service # group 1 (Use real server group 1 for http service)