NEC Express 5800/320Lc - Manual (Page 105)

Windows Setup and Operation 3-31
1) If the HDD has no partition/volume, the LED remains illuminating green.
The [Op State: State] status of both HDDs shown in the RDR Utility changes to “Duplex”.
5. After the Disk LED of both HDDs are illuminated green and the [Op State: State] status
changes to “Duplex”, right-click the HDD inserted in the step 3 in the RDR Utility, and
execute the “Resynchronize This Disk” command.
IMPORTANT:
Be sure to execute the command to the HDD inserted in step 3 because it may cause
the loss of the data in the disk when you execute the command to the other disk.
See the figure below regarding the correspondence between the slot and the RDR
Utility.
<Correspondence between the HDD slot and the RDR Utility>
RDR Utility
PCI module (Group1)
Slot1
Slot2
Slot3
PCI module (Group2)
Slot1
Slot2
Slot3