Removing pci board – NEC Express 5800/320Lc User Manual
Page 340
System Upgrade 8-39
Removing PCI Board
Follow the procedure below to remove the PCI board.
1.
Remove the PCI module.
2.
Remove the PCI module’s top cover.
3.
Remove the PCI board retainer bracket to dismount the PCI board.
In the case of a long board, unscrew the guide at the other edge and slide it to the front of
the board.
4.
Install the additional slot cover to the open slot.
5.
Install the connector cover to the relevant slot.
6.
Attach the PCI board retainer bracket.
7.
Install the PCI module’s top cover.
8.
Install the PCI module.
Do not close the release lever yet.
9.
Connect the network cable and option cables.
10.
Close the release lever.
The installed PCI module will start automatically.
11.
Secure the release lever with the setscrew.
12.
Check the PCI module status LED and PCI board status LED.
For description of LED indications, see “LEDs” in Chapter 2 and “Setup of Optional PCI
Board” later in this chapter.