NEC Express 5800/320Lc - Manual (Page 93)

Windows Setup and Operation 3-19
5. Insert a disk to set duplex configuration into the corresponding slot.
(In this example, a disk is inserted into the Slot 2 of the PCI module for Group2.)
6. On the left tree on [RDR Utility], right-click the disk which was inserted in the previous
step and click [Add RDR Virtual Disk].
IMPORTANT:
If the inserted disk has not been initialized on Windows, RDR is set and
synchronization starts automatically, so this step is not required. Skip to the next step
and check the duplex status.
7. Click [Logical Disk Information] and then [RDR Virtual Disk x](x=1,2,3) to confirm
that the synchronization is started.
IMPORTANT:
The time required for synchronization varies depending on the partition size on
the disk.
For 18GB partition, it takes about 16 minutes.
When there is no partition, synchronization may be completed in a short period of
time after RDR is set and the status may change to what is described in the step 8.
The percentage changes from 0 to 25, 50, 75 depending on the synchronization
process progresses.