NEC Express 5800/320Lc - Manual (Page 215)

5-52 Installing and Using Utilities
Diagnostics
The NEC Express5800/ft series provides the self-check diagnosis function for some components. If
a fault occurs in a component, the NEC Express5800/ft series can diagnose the component to detect
the fault.
To diagnose a component with the NEC ESMPRO Manager, use the [Maintenance] tree of the
component in the data viewer. Open the tree of the component to be diagnosed and select the
[Maintenance] tree.
To diagnose of a component with the ft server utility, use the utility screen of the component.
The table below shows the potential cases in which a component is to be diagnosed.
Diagnosis
Component
Remote Local
CPU Module When a phenomenon causing the
module to be down occurs or a
phenomenon supposed to be a
malfunction occurs.
Executable in any of the following
module states (this can be viewed on
manager screen):
• Removed
• Broken
• Shot
• Firmware Update Complete
To diagnose the module under
operation, bring down the module
before the diagnosis.
When a phenomenon causing the
module to be down occurs or a
phenomenon supposed to be a
malfunction occurs.
Executable in any of the following
module states:
• When the status LED 1 is red and
the status LED 2 is off
Only the status LED 1 illuminates red
when the module is in one of the
following states:
• Removed
• Broken
• Shot
• Firmware Update Complete
(no fault found by diagnosis)
To diagnose the module under
operation, bring down the module
before the diagnosis.
PCI Module Same as above Same as above
Remote: Executable from remote management PC by using NEC ESMPRO Manager
Local:
Executable on local server by using ft server utility
–: Not support