Netopia Router PN Series - Manual (Page 114)

5-10 Reference Guide
IPX packet filters
For each IPX packet filter, you can configure a set of parameters to
match on the source or destination attributes of IPX data packets
coming from or going to the WAN.
Viewing and modifying packet filters
To display a view-only table of IPX packet filters, select
Show/Change IPX Packet Filters in the IPX Filters and Filter Sets
screen.
To modify any of the filters in the table, note the desired filter and
press Return to go to the Change Packet Filter screen. The
parameters in this screen are the same as the ones in the Add
Packet Filter screen (see the next section).
Adding a packet filter
To add a new IPX packet filter, select Add IPX Packet Filter in the
IPX Filters and Filter Sets screen and press Return to go to the Add
Packet Filter screen.
Add Packet Filter
Filter Name: IPX Filter 1
Source Network: 00000000
Source Node Address: 000000000000
Source Socket: 0000
Destination Network: 00000000
Destination Node Address: 000000000000
Destination Socket: 0000
ADD FILTER NOW CANCEL
Configure a new IPX Packet Filter. Finished? ADD or CANCEL to exit.