Netopia Router PN Series - Manual (Page 37)

Configuring ISDN and Leased Line Connections 2-21
Note: Using the IPX protocol is required with other remote
networks using IPX for an intranet connection. For more
information on IPX, refer to Chapter 5, “IPX Setup” of this
guide.
■ Select IPX Profile Parameters and press Return. This option is
only available if IPX Enabled is toggled to Yes.
IPX Profile Parameters
Remote IPX Network: 00000000
Path Delay: 10
NetBios Packet Forwarding: Off
Incoming Packet Filter Set... <<NONE>>
Outgoing Packet Filter Set... <<NONE>>
Incoming SAP Filter Set... <<NONE>>
Outgoing SAP Filter Set... <<NONE>>
Periodic RIP Timer: 60
Periodic SAP Timer: 60
Configure IPX requirements for a remote network connection here.
■ Select Remote IPX Network and enter the network address of
the IPX network being called. Do not use an address already in
use by another connection profile
. If this value is set to zero
and the Netopia Router is answering a call, the remote address
will be learned when the profile is active.
Note: If you are trying to connect two Netopia Routers using
Frame Relay and IPX, be sure to enter an IPX address for the
remote side in the connection profiles. If the remote IPX
address is all zeros (the default), the two Netopia Routers will
not be able to connect.
Note: Unlike IP, the IPX network address is never used in
matching a profile when answering a non-authenticated call.