Netopia Router PN Series User Manual
Page 208
10-4
Reference Guide
2.
Select Packets to Send to change the default setting. This is
the total number of packets to be sent during the Ping test. The
default setting is adequate in most cases, but you may change
it to any value from 1 to 4,294,967,295.
3.
Select Data Size to change the default setting. This is the size,
in bytes, of each Ping packet sent. The default setting is ade-
quate in most cases, but you may change it to any value from 0
(only header data) to 1664.
4.
Select Delay (seconds) to change the default setting. The
delay, in seconds, determines the time between Ping packets
sent. The default setting is adequate in most cases, but you
may change it to any value from 0 to 4,294,967. A delay of 0
seconds forces packets to be sent immediately one after
another.
5.
Select START PING and press Return to begin the Ping test.
While the test is running, the START PING item becomes STOP
PING. To manually stop the Ping test, select STOP PING and
press Return or the Escape key.
While the Ping test is running, and when it is over, a status field and
a number of statistical items are active on the screen. These are
described below.
Status: The current status of the Ping test. This item can display
the following messages: