Netopia Router PN Series - Manual (Page 38)

2-22 Reference Guide
■ To change the default Path Delay, select and enter a value (in
ticks).
■ To enable NetBIOS Packet Forwarding, toggle the selection to
Yes.
■ Select Incoming Packet Filter Set to attach a filter set for
filtering incoming packets. Choose a filter set from the list and
press Return.
■ Select Outgoing Packet Filter Set to attach a filter set for
filtering outgoing packets. Choose a filter set from the list and
press Return.
■ Select Incoming SAP Filter Set to attach a filter set for filtering
server entries within incoming Service Advertising Protocol
(SAP) packets. Choose a filter set from the list press Return.
■ Select Outgoing SAP Filter Set to attach a filter set for filtering
server entries within outgoing Service Advertising Protocol
(SAP) packets and choose a filter set from the list.
■ Select Periodic RIP Timer, and enter a new value (in seconds)
to change the periodic RIP timer’s default value.
■ Select Periodic SAP Timer, and enter a new value (in seconds)
to change the periodic SAP timer’s default value.
■ Press the Escape key to go back to the Add Connection Profile
screen when you are finished configuring IPX Profile
Parameters.
For more information on creating an IPX filter set, go back to the
Advanced Configuration screen and select the Filter Sets (Firewalls)
screen. Also refer to Chapter 6, “IPX Setup”.
7. Select Data Link Encapsulation and highlight the method of
encapsulation that you want to use from the pop-up menu. The
choices offered are PPP, HDLC, or Frame Relay. Press Return.
If you have enabled PPP/MP, go to step 8. If you have enabled
Frame Relay, go to step 9. If you have enabled HDLC, go to step
11.
8. Select Data Link Options and press Return. The PPP/MP
Options screen appears.