Netopia Router PN Series - Manual (Page 35)

Configuring ISDN and Leased Line Connections 2-19
The default address for the Local WAN IP Address is 0.0.0.0,
which allows for dynamic addressing, when your ISP assigns an
address each time you connect. However, you may enter
another address if you want to use static addressing.
Note: When using Cisco-HDLC datalink encapsulation and
Network Address Translation, you must use a static address.
When using numbered inter faces, the Netopia Router will use
its local WAN IP address and subnet mask to send packets to
the remote router. Both routers have WAN IP addresses and
subnet masks associated with the connection.
IP Profile Parameters
Address Translation Enabled: No
IP Addressing... Unnumbered
Remote IP Address: 0.0.0.0
Remote IP Mask: 0.0.0.0
Filter Set...
Remove Filter Set
Receive RIP: No
Transmit RIP: No
Configure IP requirements for a remote network connection here.
■ If your ISP uses Unnumbered (System-based) Routing, select
Remote IP Address and enter the IP address your ISP gave you.
Then select Remote IP Mask and enter the IP subnet mask of
the remote site you will connect to.
Note: If your ISP has not given you their IP or subnet mask
addresses, then you may enter an IP address such as
127.0.0.2 and an IP subnet mask such as 255.0.0.0.
When using unnumbered inter faces, the Netopia Router will
use either its local Ethernet IP address or its NAT (Network
Address Translation) address (if so configured) and subnet
mask to send packets to the remote router. Neither router has