Netopia Router PN Series - Manual (Page 47)

Configuring ISDN and Leased Line Connections 2-31
If a connection is establishing properly, the Connection State will
initially read Acquiring but will change to Up once the call has
successfully connected. You will be able to access information at
the remote site that you are connecting to once authentication is
completed successfully.
Disconnecting a WAN Connection
Switched circuit models
only
To hang up a manual WAN connection call, select Disconnect WAN
Connection from the Connection Profiles screen and press Return.
The Disconnect pop-up menu displays a table of all of the
connection profiles you have previously defined. Highlight the
connection profile you wish to disconnect. Press Return and the
connection you select will be disconnected. Press Esc to cancel.
Frame Relay configuration
If you chose Frame Relay as your datalink encapsulation type you
will now need to configure your Netopia Router to support Frame
Relay. From the WAN Setup screen, select the Frame Relay
Configuration option and press Return.
The Frame Relay Configuration screen consists of two pop-up
menus. Use the information in the Leased Line worksheet in the
Getting Started Guide as a reference when specifying this
configuration information.