Nortel Networks ALTEON OS BMD00007 - Manual (Page 236)

Alteon OS Command Reference
238 „ The Configuration Menu BMD00007, November 2007
/cfg/l2/gvrp
GVRP Configuration
Use the following commands to configure Generic VLAN Registration Protocol (GVRP).
[GVRP configuration Menu]
port - Port menu
jtime - Set GARP join time
ltime - Set GARP leave time
latime - Set GARP leave all time
dynamic - Enable/disable dynamic VLAN creation
on - Globally turn GVRP On
off - Globally turn GVRP Off
current - Display current GVRP parameters
Table 6-42 GVRP Menu Options (/cfg/l2/gvrp)
Command Syntax and Usage
port
Displays the GVRP port menu. To view menu options, see page 239 .
jtime <100-65535>
Configures the time interval between GARP Join messages, in milliseconds.
The default value is 200.
ltime <100-65535>
Configures the GARP Leave time value, in milliseconds. The Leave time is the interval the switch
waits before removing the port from a VLAN on which it received the Leave message.
The default value is 600.
latime <100-65535>
Configures the time interval for GARP Leave-All messages, in milliseconds.
The default value is 10000.
dynamic enable|disable
Enables or disables dynamic VLAN creation. If you disable dynamic VLAN creation, existing
dynamic VLANs persist in the switch, but no new dynamic VLANs are created. To remove all
existing dynamic VLANs, turn GVRP off.
on
Globally turns GVRP on. With GVRP on, the GbESM processes GPDUs.