Nortel Networks ALTEON OS BMD00007 - Manual (Page 273)

Alteon OS Command Reference
The Configuration Menu „ 275 BMD00007, November 2007
/cfg/l3/ospf/if <interface number>
OSPF Interface Configuration
disable
Disables the OSPF summary range.
delete
Deletes the OSPF summary range.
current
Displays the current OSPF summary range.
[OSPF Interface 1 Menu]
aindex - Set area index
prio - Set interface router priority
cost - Set interface cost
hello - Set hello interval in seconds
dead - Set dead interval in seconds
trans - Set transit delay in seconds
retra - Set retransmit interval in seconds
key - Set authentication key
mdkey - Set MD5 key ID
enable - Enable interface
disable - Disable interface
delete - Delete interface
cur - Display current OSPF interface configuration
Table 6-72 OSPF Interface Configuration Menu Options (/cfg/l3/ospf/if)
Command Syntax and Usage
aindex <area index (0-2)>
Configures the OSPF area index.
prio <priority value (0-255)>
Configures the priority value for the GbE Switch Module’s OSPF interfaces.
(A priority value of 255 is the highest and 1 is the lowest. A priority value of 0 specifies that the
interface cannot be used as Designated Router (DR) or Backup Designated Router (BDR).)
cost <cost value (1-65535)>
Configures cost set for the selected path—preferred or backup. Usually the cost is inversely pro-
portional to the bandwidth of the interface. Low cost indicates high bandwidth.
Table 6-71 OSPF Summary Range Configuration Menu Options (/cfg/l3/ospf/range)
Command Syntax and Usage