Nortel Networks Enterprise Edge Feature Programming Telephone - Manual (Page 69)

Forwarding your calls 69
P0908510 Issue 01 Enterprise Edge Feature Programming Telephone Guide
• Enter an external telephone number (using no more than 24 digits) then press
˙ or OK .
• Press
˙
or OK if the line you have chosen as the outgoing line is a private
network line that does not require you to dial digits.
If you use ALL to redirect all your lines, it is important that you wait until all the lines
on your telephone light up before pressing ˙ or OK. If you press ˙ or
OK before all the lines light up, those lines not lit are not redirected.
Canceling Line Redirection
ƒ£°›
1. Press ƒ£°› .
2. Select the lines you no longer want to be redirected.
Allowing a telephone to redirect calls
You can turn a telephone’s ability to redirect calls on and off.
You need to start a Unified Manager session to program this feature. See Getting
Started on page 13 for more information.
1. Select Terminals & Sets.
2. Select a DN number.
3. Double-click Capabilities.
4. Choose an Allow redirect setting: Yes or No.
Tip
The line chosen for redirecting calls on other lines can be used normally when
it is not busy on a redirected call. To avoid redirection failing because the
chosen line is in use, choose a line pool with several lines in it.
The system does not check that the number you give for line redirection is a
valid one. If you redirect to an invalid number, redirection fails. Using an
autodial button to enter the redirection number helps avoid this possibility. An
autodial button used for line redirection must be programmed to use a specific
line.