National Instruments Graphical User Interface Ultiboard - Manual (Page 127)

Chapter 4 Working with Parts
© National Instruments Corporation 4-31 NI Ultiboard User Manual
Complete the following steps to add a vertex to any line segment of a
polygon:
1. Select the line (a selected line segment will have filled selection boxes
while the other selection boxes in the polygon will be open).
2. Select Edit»Vertex»Add Vertex. A vertex is added in the middle of
the segment.
You can now move that vertex to change the shape of the polygon.
Complete the following steps to remove a vertex:
1. Click on the point to be removed.
2. Choose Edit»Vertex»Remove Vertex. The vertex is removed, and the
vertices on either side are joined by a straight line.
Complete the following to change the size of a design’s vertices:
1. Edit the Minimum control point size field in the General tab of the
Preferences dialog box. Refer to the
General Tab section of
Chapter 1, User Interface , for more information.
Viewing and Editing Through Hole Pin Properties
Complete the following steps to edit through hole pin properties:
1. Select the desired through hole pin and select Edit»Properties.
2. The Through Hole Pin Properties dialog box appears, consisiting of
five tabs: Attributes, General, Pad, Layer Settings and Thermal
Relief.