National Instruments Graphical User Interface Ultiboard - Manual (Page 63)

Chapter 1 User Interface
© National Instruments Corporation 1-47 NI Ultiboard User Manual
Commands Tab
The Commands tab in the Customize dialog box is used to add commands
to menus and toolbar.
Complete the following steps to add a command to a menu or toolbar:
1. Drag the desired command from the Commands list to the desired
menu or toolbar. When a command is selected in the Command list,
its description is displayed in the Description field.
2. If you do not see the command that you require, click on another
selection in the Categories list to display more commands.
3. If you wish to add a button to a toolbar that is not showing, click on the
Toolbars tab and click in the checkbox beside the desired toolbar to
make it visible.
4. Click Close when customizations are complete.
To remove a command from a menu or toolbar, right-click on it and select
Delete from the pop-up that appears. The Customize dialog box must be
open when you do this.
To change the position of a command that is in a menu or toolbar, drag it to
its new location. The Customize dialog box must be open when you do
this.
Toolbars Tab
The Toolbars tab in the Customize dialog box is used to show or hide
toolbars, and to add new custom toolbars.
Complete the following steps to use the features in this tab:
1. To display a toolbar, switch on the checkbox beside the desired toolbar
in the Toolbars list.
2. Switch off a checkbox to hide a toolbar.
Note You cannot switch off the Menu bar.