National Instruments Graphical User Interface Ultiboard - Manual (Page 25)

Chapter 1 User Interface
© National Instruments Corporation 1-9 NI Ultiboard User Manual
Place Toolbar
The Place toolbar contains the functions used to place elements such as
traces, lines and polygons on the design. The Place toolbar buttons are
explained in the table below.
Space Down Plus button. Increases vertical space
between two or more objects.
Space Down Min button. Decreases vertical space
between two or more objects.
Button Description
Place Comment button. Places a comment on the design.
Refer to the
Placing a Comment section of Chapter 8,
Preparing for Manufacturing/Assembly , for more
information.
Capture Area button. Captures a section of the screen
and places it on the system clipboard.
Select button. De-activates any selected mode (for
example, for placing traces) and allows you to select an
element on the board.
Place Line button. Places a line on the design (or place a
trace, when used on a copper layer). Refer to the
Placing
Shapes and Graphics section of Chapter 4, Working with
Parts , for more information.
Place Arc button. Places an arc on the design. Refer to the
Placing Shapes and Graphics of Chapter 4, Working with
Parts , section for more information.
Place Bezier button. Places a bezier curve on the design.
Refer to the
Placing Shapes and Graphics section of
Chapter 4, Working with Parts , for more information.
Place Circle button. Places a circle on the design. Refer
to the
Placing Shapes and Graphics section of Chapter 4,
Working with Parts , for more information.
Button Description