National Instruments Graphical User Interface Ultiboard - Manual (Page 28)

Chapter 1 User Interface
NI Ultiboard User Manual 1-12 ni.com
Wizard Toolbar
The Wizard toolbar contains the wizard functions supported by Ultiboard.
The Wizard toolbar buttons are explained in the table below.
Autoroute Toolbar
The Autoroute toolbar contains the autorouting and placement functions
supported by Ultiboard. The Autoroute
toolbar buttons are explained in the
table below.
Polygon Splitter button. Splits copper areas and
powerplanes. Refer to the
Splitting Copper section of
Chapter 5, Working with Traces and Copper , for more
information.
Remove Copper Islands button. Removes copper
islands. Refer to the
Placing Copper Areas section of
Chapter 5, Working with Traces and Copper , for more
information.
Button Description
Board Wizard button. Starts the Board Wizard. Refer to
the
Working with the Board Outline section of Chapter 3,
Setting Up a Design , for more information.
Part Wizard button. Starts the Part Wizard. Refer to the
Using the Part Wizard to Create a Part section of
Chapter 4, Working with Parts , for more information.
Button Description
Begin Autoplacing button. Starts automatically placing
parts.
Autoroute Selected Buses button. Displays the Bus
Autorouting dialog.
Start Trace Optimization button. Starts trace
optimization.
Button Description