Controlling workspace elements for mechanical cad, Controlling workspace elements for mechanical – National Instruments Graphical User Interface Ultiboard User Manual
Page 240
Chapter 10
Using Mechanical CAD
10-4
ni.com
Controlling Workspace Elements for Mechanical
CAD
The General tab allows you to control whether or not invisible attributes
or cross hairs are shown in normal view, and options for full screen view.
This tab also allows you to have Ultiboard load your last project
automatically, and to have Ultiboard automatically save your project at
specified intervals.
Complete the following steps to view or change workspace options:
1.
Choose Options»Global Preferences. The Preferences
dialog box
appears.
2.
Click the General tab.
3.
Adjust the View box settings as desired:
•
Show invisible attributes—These are set up in the Attributes tab
(Visibility column) of the element’s properties dialog.
•
Show crosshair—Displays a large crosshair that is attached to
your mouse’s pointer.
4.
Adjust the Crosshair box settings as desired:
•
Keep always on grid—Makes sure that the crosshair will always
snap to grid points even when you are not placing any parts or
traces (normally when you are not placing parts or traces the
crosshair moves gridless.
•
Drop on left mouse button—Changes the way moving of objects
works. Normally when you start a move, the object will be
dropped when you release the left mouse button. When this option
is enabled, releasing the mouse button will not drop the part - only
pressing the left mouse button will.
5.
Adjust the Fullscreen mode box settings as desired:
•
Show scrollbars—Places vertical and horizontal scrollbars in the
fullscreen view. Use these to move to the desired area on the
workspace.
•
Autopan—Automatically moves the view of the workspace as
you move the cursor offscreen.
6.
Increase or decrease the Undo buffer size as desired. The number here
is the number of undo actions allowed.
7.
In the File box, enable Load last file on startup
if you would like to
continue working on the last file you had open in your previous
Ultiboard session.
8.
Select the desired settings in the Mouse Wheel Behavior
box.