Adding parts to the database, Adding parts to the database -44 – National Instruments Graphical User Interface Ultiboard User Manual
Page 140
Chapter 4
Working with Parts
4-44
ni.com
3.
Select the category or sub-category where the category is to be copied.
The copied category will go under the item you select.
4.
Click OK. The category is copied to the location you specified, and the
Select destination in database dialog box disappears.
Complete the following steps to delete a database sub-category:
1.
In the Database panel, select the sub-category to be deleted.
2.
Click the Delete button above the Database panel. You are prompted
to confirm the deletion. The sub-category disappears from the list.
Complete the following steps to rename a database sub-category:
1.
In the Database panel, select the sub-category to be renamed.
2.
Click the Rename button above the Database panel. The name of the
sub-category is highlighted.
3.
Change the name as desired.
Complete the following steps to move a database category or sub-category:
1.
In the Database panel, select the category or sub-category to be
moved.
2.
Click the Move button above the Database panel. The Select
destination in database dialog box appears.
3.
Select the category or sub-category where the category is to be moved.
The moved category will go under the item you select.
4.
Click OK. The category is moved to the location you specified, and the
Select destination in database dialog box disappears.
Adding Parts to the Database
Parts that appear on a design but do not exist in the database can be added
to the database two ways:
•
By using the Database Manager.
•
By using Tools»Database»Add Selection to Database.