National Instruments Graphical User Interface Ultiboard User Manual
Page 90
Chapter 3
Setting Up a Design
3-14
ni.com
6.
Click OK to return to the Part Groups tab. The newly created group
appears in the Groups list.
7.
Highlight the new group to display a list of parts you can add to the
group in the Assign Parts list, as shown in the example below.
8.
Click checkboxes beside the desired parts in the Assign Parts list and
click Apply to add them to the group.
Note
You cannot assign a part to more than one group. Therefore, parts that are already
assigned to another group do not appear in the Assign Nets list.
9.
Click OK to close the Edit Groups dialog box.
Tip
When adding parts to a Part Group, you can select parts on the workspace and then
click Add Selected in the Part Groups tab—the selected parts are added to the group.