National Instruments Graphical User Interface Ultiboard - Manual (Page 160)

Chapter 5 Working with Traces and Copper
NI Ultiboard User Manual 5-16 ni.com
Note Depending on your setting in the PCB Design tab of the Preferences dialog box,
vias associated with a trace may be deleted when the trace is deleted.
Viewing and Editing Via Properties
Via properties consist of five tabs: Attributes, General, Via , Layer
Settings and Thermal Relief.
The Attributes tab allows you to edit the properties of the selected via.
Refer to the
Attributes section of Chapter 4, Working with Parts , for more
information.
The General tab is the default, and appears when you choose
Edit»Properties. It allows you to change the X/Y coordinates, the size of
the clearance, the via angle, the side of the board the via is on, and to define
the units of measurement.
Complete the following steps to change the settings in the General tab:
1. In the Measurements box, set the following as desired:
• X,Y—The X and Y coordinates of the via.
• Net—The net the via is connected to (read-only).
• Angle(degrees)—Leave at 0.00.
• Board side—Select either Top or Bottom radio button
(read-only).
2. Optionally, enable the Locked checkbox to lock the via in place, and
change the Units of measurement.
3. In the Clearances box, enter the desired clearance of the selected via
to traces in the To Trace field.
Complete the following steps to change the settings in the Via tab:
1. Enable the Assume net checkbox to assign a specific net to the via,
then select the net from the drop-down list.
2. In the Via Settings box, set the following as desired:
• Use Design Rules radio button—Select to use the settings in the
Pads/Vias tab of the PCB Properties dialog box.
• Pad Diameter radio button—Select to enter the diameter of the
selected via’s pad in the drop-down list. The Drill Diameter
drop-down list is also activated; enter the desired value.
• Plated checkbox—Check to plate the inside of the via’s drill hole.