Nortel Networks NN46110-602 - Manual (Page 115)

Chapter 5 Packet capture 115
Nortel VPN Router Troubleshooting
For example, enter:
CES(capture-ethernet) #maxfiles 99
Saving captured data
To set the PCAP capture mode to loss or no loss, from CLI Capture Configuration
Mode enter:
capture-all
or
No capture-all
For example, enter:
CES(capture-ethernet) #capture-all
Configuring and running packet capture objects
This section provides instructions for creating, configuring, starting, and stopping
capture objects, as well as instructions for saving captured traffic to a file on disk.
For the complete syntax of the packet capture commands shown in this section,
see the Nortel VPN Router Using the Command Line Interface.
Creating a capture object
To create a capture object, use the
capture add
command. (For information about
the types of object that you can create, see “Capture types” on page 106 .)
1 To view the types of capture objects that you can configure, enter the
following command at the Privileged EXEC prompt.
CES# capture add <object_name> ?