Figure 1, Admin > snmp traps window – Nortel Networks NN46110-602 User Manual
Page 33
Chapter 1 VPN Router administration 33
Nortel VPN Router Troubleshooting
Figure 1 Admin > SNMP Traps window
2
Enter a host name or IP address in the Host Name or IP Address text box.
3
Enter a name in the Community Name text box.
4
Click Enable.
5
Click OK.
6
Under the Trap Groups section on the SNMP Traps window, click
Configure beside Service.
7
Click OK.
The Service Trap Configuration window appears.
8
Click Enable for User IP Address Pool.
9
Click OK.
The Address Pool window appears.
10 In the Address Pool Exhausted Amount text box, enter the limit of an IP
pool that triggers an SNMP trap. The range is from 50 to 99 and the default is
70.
11 In the Address Pool Blackout Interval, enter in seconds the amount of time
before an address is available for reissue. The default is 10.
12 Click OK.
You can also use the CLI to configure an SNMP trap to send a notification about
an exhausted IP address pool.
To configure the interval:
CES(config)#$enable traps service ip-pool-exhausted interval
<hh:mm:ss> [send-one]