Connect copy when memory is full – Ricoh 850 User Manual
Page 328
What to do if Something Goes Wrong
280
5
Connect Copy
When Memory is Full
If the number of originals exceeds a certain limit, the machine will run out of
memory, for Connect Copy scans in all your originals into memory.
Limitation
❒ If memory is full on either the master unit or sub-unit, Interrupt will not be
available.
Note
❒ If you set the “Memory Full Auto Scan Restart” setting in the User Tools
(Copier/Document Server Features) to “Yes”, the memory overflow message
will not be displayed, but originals scanned so far will be copied automatical-
ly. Connect Copy continues scanning and copying until finishing the job.
Please note that copy sets will be printed out separated by scanning at this
time.
Machine Status
Cause
Action
You can not use the Punch
function.
The sub-unit does not have
the optional punch kit.
Press the
[Connect Copy]
key to disconnect, then
start copying.
The copied images differ.
The “Original Mode” of the
user tools (Copy Features)
settings are not the same.
The user stamp settings are
not the same on the master
unit and sub-unit.
Register the same stamp in
each user stamp.
Machine Status
Action
The memory is full.
Press the
[Output]
key to copy scanned
originals and clear the scanning data.
Press the
[Clear]
key to clear the scanning
data and not copy.
The machine asks you whether you want
to scan the remaining originals.
To continue copying, remove all copies
then press the
[Resume]
key. To stop copy-
ing, press the
[Cancel]
key.