Ricoh 850 - Manual (Page 586)

Copying
136
2
Center/Border Erase
This function erases the center and/or all four sides of the original image. This
is useful for avoiding shadows on the copy image caused by the binding or
splayed pages of books etc.
Two modes of this feature are available:
❖ Center
This mode erases the Center margin of the original image.
❖ Border
This mode erases the edges area of the original image.
Limitation
❒ This function will not take effect if the size of the original cannot be detected.
Note
❒ You can change the width of the erased margin as follows:
❒ The default width of the erased margin is as follows. You can change this set-
tings with the User Tools. See “Border Erase Width”
⇒
P.320 “Adjust Image”
and “Centre Erase Width”
⇒
P.320 “Adjust Image”.
❒ The width of the erased margin varies depending on the reproduction ratio.
❒ If the size of the original is different from sizes listed in the following chart,
the erased margin might be shifted.
Metric version 3 – 50 mm (in 1 mm steps)
Inch version 0.1" – 2.0" (in 0.1" steps)
Metric version 10 mm
Inch version 0.4"