Ricoh 850 - Manual (Page 517)

Other Functions
67
2
Other Functions
Energy Saver Mode
If you do not operate the machine for a certain period after copying, or when you
press the {
Energy Saver } key, the display goes blank and the machine enters En-
ergy Saver mode. When you press the { Energy Saver } key again, when the origi-
nals are set in the document feeder, or when the document feeder is opened, the
machine returns to the ready condition. In Energy Saver mode, the machine uses
less electricity.
Energy Saver mode makes a two-step reduction in electricity: one for the period
up to the time set for Panel Off & Energy Saver mode, the other for the period
after that time.
Note
❒ If you press the { Energy Saver } key during an operation, the current settings
will be cleared.
❒ It takes about 5 seconds to return to the ready condition from Energy Saver
mode.
❒ It takes about 40 seconds to return to the ready condition from Panel Off &
Energy Saver mode.
❒ If you press the [Connect] key on the master unit, the sub-unit exits Energy
Saver mode and enters Connect Copy mode.
❒ In Connect Copy mode, the sub-unit will not enter Energy Saver mode.
Reference
See “Panel Off Timer” and “Energy Saver Timer” in the System Settings man-
ual for more information.
Interrupt Copy
Use this function if you wish to interrupt a long copy job to make urgently need
copies.
Note
❒ The procedure for making interrupt copies depends on which kind of opera-
tion the machine is currently carrying out.
❒ You can use Document Server mode in Interrupt Copy mode.
❒ In Connect Copy mode, you cannot use Interrupt Copy function on the sub-
unit while the master unit is scanning an original.
❒ In Connect Copy mode, you cannot use Interrupt Copy function when mem-
ory on the sub-unit is full.
❒ Please exit the Interrupt mode after finishing the job.