Thermador PRL48 - Manual (Page 5)

English 3
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
WARNING — ALL MODELS:
IN CASE OF AN ELECTRICAL FAILURE
If for any reason a gas control knob is turned ON
and there is no electrical power to operate the
electronic igniters on the range's cooktop
burners, turn OFF the gas control knob and wait
5 minutes for the gas to dissipate before lighting
the burner manually.
To light the burners manually, carefully hold a
lighted match to the burner ports and turn the
gas control knob to . During a power failure,
you can use the standard cooktop burners, but
each must be lit with a match.
DO NOT attempt to light the two left burners
manually. These burners are equipped with the
ExtraLow ® feature and cannot be lit manually.
TESTED IN ACCORDANCE WITH:
• ANSI Z21.1 for Household Gas Appliances
• UL858 for Household Electric Ranges
• CAN/CSA-22.2 No. 61-08 for Household Cooking
Ranges
• CAN/CGA 1.1-M81 Domestic Gas Ranges
Check your local building codes for the proper method of
installation. In the absence of local codes, this unit should
be installed in accordance with the National Fuel Gas Code
No. Z223.1 current issue and the National Electrical Code
ANSI/NFPA No. 70 current issue or the Can - B149
Installation Codes for Gas Burning Appliances and C22.1
Canadian Electrical Code Part 1.
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.