TurboChef Technologies High h Batch - Manual (Page 102)

71 G L O S S A R Y O F T E R M S
Air Diffuser Plate
Accessory plate that covers openings in the
jetplate for very delicate cooking.
Air Diverter Plate
Covers the Catalytic Converter.
Blower Motor
Located in back of oven, the Blower Motor
actuates the impingement process. Actuated by
Blower Motor Controller.
Blower Motor Controller (BMSC)
Proprietary brushless DC Blower Motor
Controller actuates the Blower Motor.
Catalytic Converter
Part of Filtering System, the Catalytic Converter
cleans recirculating airflow.
CC Thermocouple
See Thermocouple – CC
Component Plate
Plate to which the I/O Control Board, Power
Supply, Relay, Smart Card Reader, and Solid State
Relay are attached.
Control Board
See I/O Control Board
Control System
System that signals, senses, commands, and
actuates the oven’s other various components.
Cook Chamber
Chamber in which food cooks.
Cook Chamber Temperature
Actual temperature of the Cook Chamber regis-
tered by the Cook Chamber Thermocouple.
Cook Counter
Function on Test Mode Menu that displays number
of Cook Cycles the oven has completed.
Cook Cycle
All operative aspects of cooking a product.
Cook Time
Function on Test Mode Menu that displays the
cumulative time of Cook Cycles.
Cool-down State
State during which the Blower Motor blows cool
air into the Cook Chamber until the temperature
is below 150ºF (66°C). Takes approx. 90 minutes.
Cooling Fans
Inlet and exhaust fans that ventilate the Electrical
Compartment.
Cooling Fan – Exhaust
Air that ventilates the Electrical Compartment
exits through the exhaust fan.
Cooling Fan – Inlet
Air that ventilates the Electrical Compartment
enters through the inlet fan.
Cooling Fan Thermostat
See Thermostat – Cooling Fan
Cumulative Operating Time
Function on Test Mode Menu that displays
cumulative time of oven operation (i.e., total time
oven has been on).
Daily Maintenance
Procedure that operator should apply every day to
ensure oven remains in optimal condition.
Deep Clean
Process that operator and/or technician should
apply approximately once per month (or more
frequently as needed) to ensure oven remains in
optimal condition.
Demonstration Mode
Accessible from the Options Menu. Allows the
operator to view/show every operational aspect of
the oven without the oven actually heating up.