TurboChef Technologies High h Batch - Manual (Page 41)

D I A G N O S I N G A N I S S U E
NOTE: Adjustments can be made only in
Fahrenheit. (5ºF equals approximately 2.8ºC.)
NOTE: At 20°F, pressing the “OFFSET” Soft Key
rolls the Temperature Offset back to 0°F.
3. Press “ENTER” to confirm.
4. When finished, press the “BACK/STOP” Key to
exit the Test Mode Menu.
Checking Heaters A and B (Figures 30-31)
NOTE: If the Blower Speed is “0”, the Blower will
automatically set to idle airflow at the initiation of
this test.
To turn on Heater A: (Figure 30)
1. From Screen 1 of the Test Mode Menu, press
the “HEATER A” Soft Key (top right).
2. When finished testing, press the “HEATER A”
Soft Key (top right) to turn Heater A off.
3. Press the “BACK/STOP” Key to end the test
and exit the Test Mode Menu.
To turn on Heater B: (Figure 31, page 26)
1. From Screen 1 of the Test Mode Menu, press
the “HEATER B” Soft Key (middle right).
2. When finished testing, press the “HEATER B”
Soft Key (middle right) to turn Heater B off.
3. Press the “BACK/STOP” Key to end the test
and exit the Test Mode Menu.
LEFT
RIGHT
        : Adjusting the Temperature Offset
Step: 1/2 Step: 3 Simultaneously press and hold for 1
second to get to the Test Mode Menu
(Screen 1). NOTE: Oven must be in
the Off or Cool-down State. In this example, the Temperature Offset is
set at 20ºF (approximately 11ºC).
LEFT
RIGHT
        : Checking Heater A
Step: 1/2 Step: 3 Simultaneously press and hold for 1
second to get to the Test Mode Menu
(Screen 1). NOTE: Oven must be in
the Off or Cool-down State. In this example, Heater A is on.
25