TurboChef Technologies High h Batch User Manual
Page 63
45
T H E C O N T R O L S Y S T E M
Voltage Sensor (Figure 50)
Proprietary device designed to measure incoming
line voltage and distribute either 208 or 240 VAC
operation. The sensor is only included in ovens
operated in North and South America.
To replace a defective Voltage Sensor:
1. Ensure “Cool Down” process is completed (“Cool
Down” message will disappear upon completion)
and unplug the oven.
2. Remove Right Side Panel.
3. Remove Electrical Plate Assembly for access to
Voltage Sensor Screw.
4. Disconnect wiring from Voltage Sensor (2 wires to
Wiring Harness and 2 wires to terminal block).
5. Replace defective Voltage Sensor with P/N
100783.
6. Reconnect wiring.
7. Reattach the Electrical Plate Assembly and
side panel.
N U M B E R
PA R T
PA R T N U M B E R
56
Screw – Voltage Sensor
101688
57
Electrical Plate
HHB-8134
58
Voltage Sensor
100783
59
Grommet – Electrical Plate
100644
60
Nut – Electrical Plate Ground
100903
61
Screw – Electrical Plate (x2)
102911
: Replacing Voltage Sensor
61
60
59
58
57
56