UNICOM Electric SmartGST-2402M - Manual (Page 11)

www.unicomlink.com UNICOM
10
Connecting to the Switch
The Console port is a male DB-9 connector that enables connection of a PC or
terminal for monitoring and configuring the Switch. Use the supplied RS-232 cable
to connect a terminal or PC to the Console port.
The Console configuration (out of band) allows you to set your Switch to enable a
user at a remote console terminal to communicate with the Switch as if the remote
terminal were directly connected to it.
Console Management
Login in the Console Interface
Once you have connected the cable to the switch and the PC, turn on the PC and
run a terminal emulation program or Hyper Terminal and configure its
communication parameters to match the following default characteristics of the
console port:
Baud Rate: 9600 bps
Data Bits: 8
Parity: none
Stop Bit: 1
Control flow: None
Figure 3-3. The settings of
communication parameters
After you have completed the parameter settings, press “OK“.