UNICOM Electric SmartGST-2402M - Manual (Page 18)

UNICOM SmartGST-2402M
17
4-3-1-4. Change Password
Use this page to change Web Management user password.
4-3-2. Port Configuration
This page can change all port statuses and configure the trunk group.
Press the TAB key to select an item to configure and press SPACE to make a change.
1. State: Current port status. The port can be set to disable or enable mode. If the
port setting is disable then it will not receive or transmit any packets.
2. Negotiation: Current auto negotiation setting status of each port.
3. Speed/Duplex: User can set each port for link speed and duplex mode.
4. FC / BP: User can set flow control function to enable or disable. FC (Flow control
for full duplex link mode), BP (Backpressure for half duplex mode)
5. Bandwidth In/ Out: For per port packet transmission rate control. Per port level is
100Kbps. It supports individual control method of TX and RX.
6. Priority: Set port to high or low priority.
7. Security: Enable or disable port security function.