UNICOM Electric SmartGST-2402M - Manual (Page 76)

UNICOM SmartGST-2402M
75
Console -- 1K Xmodem Firmware Update
We provide the ability to update the 1k Xmodem firmware through the console. 1K
Xmodem only works in 57,600bps mode so in order to download the firmware update,
you must change the baud rate to 57,600bps.
There are two scenarios in which you would use the 1k Xmodem firmware update.
a. User enters "1K Xmodem receiver mode" by pressing any key within 5 seconds after
the system powers on.
b. System automatically enters "1K Xmodem receiver mode" if it detects the firmware
checksum failed while booting.
1.Press disconnect button when you start 1K Xmodem modes.
Press File -> Properties, change baud rate to 57,600bps, then press OK.