UNICOM Electric SmartGST-2402M - Manual (Page 37)

www.unicomlink.com UNICOM
36
4-4-3. LACP
This page can configure and view the LACP status.
4-4-3-1.Working Ports Setting
1. Group ID: There are seven configurable Trunking groups. Choose the “Group ID”
and click “Get”.
2. LACP: Press Space key to enable or disable LACP (Link Aggregation Control
Protocol) support. If enabled, the group is a LACP static trunking group. If disabled,
the group is a local static trunking group. All ports support LACP dynamic trunking
groups. If connecting to another device that also supports LACP, the LACP dynamic
trunking group will be automatically created.
3. Work Ports: This allows a maximum of four ports to be connected simultaneously.
In a LACP static trunking group, the excess ports are on standby and able to
aggregate if and when the work ports fail. In a local static trunking group, the number
must be the same as the group member ports.
NOTE: Before setting LACP support, you must set trunk group in Port / Trunk Configuration.