UNICOM Electric SmartGST-2402M - Manual (Page 9)

www.unicomlink.com UNICOM
8
Power On
Connect the power cord to the power socket on the rear panel of the Switch. The
other side of power cord connects to the power outlet. The internal power supply in
the Switch works with AC in the voltage range 100-240VAC, frequency 50~60Hz.
Check the power indicator on the front panel to see if power is properly supplied.
Network Application
This section provides you a few samples of network topology in which the Switch is
used. The SmartGST-2402M is designed as a segment switch. With its large
address table (6000 MAC addresses) and high performance, it is ideal for
interconnecting networking segments.
You can use the SmartGST-2402M to interconnect PCs, workstations, and servers
to each other by connecting these devices directly to the Switch. The switch
automatically learns node addresses, which are subsequently used to filter and
forward all traffic based on the destination address.
By using the Uplink feature, the Switch can connect with another switch or hub to
interconnect each of your switched workgroups forming a larger switched network.
Also you can also use the expansion port to connect switches for great distances.
The distance between two switches via fiber cable can be up to 10 Kilometers
(Gigabit LX port with Single Mode fiber).
Small Workgroup
The SmartGST-2402M can be used to create a small workgroup by directly
connecting personal computers, servers, and printer servers.