UNICOM Electric SmartGST-2402M - Manual (Page 7)

www.unicomlink.com UNICOM
6
Off No device attached or in half-duplex mode.
Table 2-1. The Description of LED Indicators
Rear Panel
The 3-pronged power plug and ventilation fan are located at the rear Panel of the
SmartGST-2402M as shown in Figure 2-2. The Switch will work with AC in the
range 100-240V AC, 50-60Hz.
Figure 2-3. The Rear Panel of SmartGST-2402M
Desktop Installation
Set the Switch on a sufficiently large flat space with a power outlet nearby. The
surface where you put your Switch should be clean, smooth, level and sturdy.
Make sure there is enough clearance around the Switch to allow attachment of
cables, power cord and allow air circulation.
Attaching Rubber Feet
A. Make sure mounting surface on the bottom of the Switch is grease and dust
free.
B. Remove adhesive backing from your Rubber Feet.
C. Apply the Rubber Feet to each corner on the bottom of the Switch. These
footpads can protect the Switch from shock and vibration.
Figure 2-4. Attaching Rubber Feet to each bottom
corner of the of the Switch