Znyx Networks bh5700 - Manual (Page 161)

Physical
Slot
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Fabric
Port 3 19 11 - - 3 7 15 27
Fabric 51**
* Base Interface Inter-Switch Link (ISL)
** 10 Gigabit Ethernet Fabric Interface - Update Channel
Table 13.2: Additional Interfaces
Additional Interfaces Base Fabric
Front Panel Egress (zre) 12 20
- 21
14 22
15 23
Shelf Manager 1 (zre) 22 -
Shelf Manager 2 (zre) 13 -
Front Panel Out-of-Band Management Port (eth) 0 0
NOTE: The Out-of-Band (
eth
) ports are not enabled by default. Edit the
S50layer2
script or
ifconfig eth0
for front panel access or
eth1
for rear panel access (not
implemented this release) on either the Base or Fabric Interfaces.
Default Base Interface Configuration
Editing the
S50layer2
script can change the Ethernet Switch Blade Base Interface default
configuration. The
S50Layer2
script and included example scripts
(/etc/rcZ.d/examples) can be used as templates to create custom scripts. The default
S50layer2
scripts configures the switch accordingly:
24 port, Layer 2 Switching, single VLAN
1.
S20stack - Script that calls
zstack
to combine the two BCM5695 twelve-port switch
fabric chips into a single 24 port virtual switch.
zstack
must be run before any other
switch configuration. (Editing this script is not recommended.)
Ethernet Switch Blade User's Guide release 3.2.2j page 161