Znyx Networks bh5700 - Manual (Page 277)

Network Interface Statements
The syntax for a network interface statement is the interface name followed by a colon and an
action. Network interface statements are used to create or tear down a VLAN group and can
consist of one or a list of network interface names; followed by a colon and then an action. For
example:
zhp0: <Network Interface Action>;
Network interface actions may include:
vlan<N> = list of ports or trunks
Creates a network interface and a VLAN group with a VLAN
identification number (VID) consisting of specified port members.
<N> is an integer between 1-4095.
list of ports or trunks
A port member is identified with the zre<X> format, where x
represents a port number between 0-23 for the in-band ports. A
trunk is identified with the zrl<Y> format, where Y is a number
between 0-31.
If the network interface and VLAN group already exist, the
specified ports or trunks are added to the network interface and
VLAN group.
teardown Deletes the network interface and the associated VLAN
group.
zre_list = multicast <mac_address>
Register the multicast <mac_address> on the zre_list ports
associated with the given VLAN
multicast_clear Clear all registered multicast address on all the
ports in the VLAN
<list of ports or trunks> teardown
Deletes the specified ports or trunks from the network interface
and the VLAN group associated with it. If there are no remaining
port or trunk members, then also deletes the network interface
and VLAN group.
Examples of Network Interface Statements:
The statement below creates a VLAN group with the VID number 1 and the network interface
named
zhp5
. This VLAN includes a single switch port, zre1.
zhp5: vlan1=zre1;
Ethernet Switch Blade User's Guide release 3.2.2j page 277