Znyx Networks bh5700 - Manual (Page 35)

Once the configuration files are complete, run the zspconfig utility on the Master to configure
all the scripts:
NOTE: This command can take 60 seconds or more with no screen output.
zspconfig –f zsp.conf
You will see output similar to this:
zspconfig -f zsp.conf
….
Would you like to install the Surviving Partner startup
script[y,n,?] y
Would you like to start the Surviving Partner daemons without
rebooting [y,n,?] y
Once configuration is complete, insure there are no superfluous S-type startup scripts in
/etc/rcZ.d, and zsync your switch to save your configuration.
Now go to the backup switch and run zspconfig –u to get the appropriate configuration
information from the Master,
zspconfig –u zhp0
Modifying zsp_vlan.conf on the Fabric Switch
An example file for setting up zspconfig on a Ethernet Switch Blade Fabric board is
/etc/rcZ.d/surviving_partner/zsp_vlan.conf. Reference the descriptions in the
previous section for descriptions of each configuration section.
# Sample configuration is based on the idea that there are
separate VLANs
# for the multiple connections to a slot.
#
# zhp0: Interconnect VLAN
# zhp1..4: Data interface VLANs, configured such that
Option 2
# slots have 2 VLANs connected to them and Option 3 slots
have
# 4 VLANs connected to them.
#
Ethernet Switch Blade User's Guide release 3.2.2j page 35