Znyx Networks bh5700 - Manual (Page 276)

A port member is identified with the zre<X> format, where x
represents a port number between 0 and 23 for the in-band ports.
The Out-of-Band ports cannot be included in the List of ports.
teardown Removes the trunk interface, making the ports which
were part of the trunk available for configuration in other
trunks or VLANs.
all
mac [ source_address | destination_address ]
ip [ source_address | destination_address ]
port [ source_port | destination_port ]
Further specifies the rules for selecting which port in the
trunk a packet should be transmitted out of. A comma delimited
list is valid to specify more than one criterion. Specifying a
particular option only uses that layer’s source and destination
information. The default is all, which combines all criteria for
determining the transmit port of the trunk. Specifying both
source and destination for a given layer is the same as
specifying that layer itself, that is,
zrl0=ip source_address, ip destination_address
is the same as,
zrl0=ip
NOTE: The base switch supports destination_address and/or source_address for
MAC and IP. It cannot combine MAC and IP settings, nor does it support port settings.
Examples of trunk interface statements:
This statement creates a trunk containing three ports:
zrl5 = zre11,zre15,zre17;
The following statement specifies that packets will be sent out over this trunk
using the exclusive OR of the last three bits of their MAC source and destination
addresses to select the port:
zrl5 = mac source_address, mac destination_address;
The teardown statement uses a colon instead of an equals sign:
zrl5: teardown
Ethernet Switch Blade User's Guide release 3.2.2j page 276