Znyx Networks bh5700 - Manual (Page 327)

zpeer peer state query
The output from the above command during the boot process would be “unhealthy”
The -a option can be used to display a complete listing of all state and priority information and
internal information that can be used for debugging. Here is example output from the -a option.
Local/Write Peer/Read
priority 203 231
state master backup
data 2|cb 2|e7
position byte|bit 2|8 2|0
status 50(ACK) 0()
The priority and state rows are the same values returned by the query command. The information
in the data, position and status rows are internal debugging information that is useful to support
engineers when diagnosing problems in the field.
The -r option should not be used while HA is running. It can cause loss of coordination between
the two switch planes. The -r option will reset all internal communication values, and possibly
require the peer to be reset also.
OPTIONS
-d set debug level to <level>
-a Display complete status of zpeer
-r Reset all values in the zpeer communication. Can cause
loss of communication with the peer requiring the peer to
be also reset.
SEE ALSO
zspconfig
Ethernet Switch Blade User's Guide release 3.2.2j page 327