Znyx Networks bh5700 - Manual (Page 307)

must be down to change the speed. Assuming zre1 is part of interface zhp0,
ifconfig zhp0 down
zlc zre1 100fd
The external fault, internal fault, and ok LEDs can be set on a per port basis or globally. To set
the external fault LED for a particular port,
zlc zre1 extfault on
To query the settings of a particular port,
zlc zre1 query
Global Settings
The external fault, internal fault, and extract LEDs are set as a logical OR of all the ports. The
LEDs can also be set globally to on, off, or other. If globally set to on or off, the LED will not
change when links go up or down ,or interfaces are configured. If set to other, the LED resumes
its normal operation.
The next example globally turns on the Pull (extract) LED.
zlc extract on
Additional capabilities are also available by supplying an additional led action:
zlc <led_name> on
The <led_name> LED is turned on. The LED will not change when links go up or down or
interfaces are configured. If
other is used, the LED resumes its normal operation.
<led_name> can be intfault, extfault, extract, or ok.
zlc query
zlc state
query lists the LEDs which have been set globally on or off. state shows which LEDs are on at the
moment. All LEDs are shown, including the clk LED.
SEE ALSO
ifconfig(8)
Ethernet Switch Blade User's Guide release 3.2.2j page 307