Znyx Networks bh5700 - Manual (Page 301)

default level is zero (0). Setting the debug level higher
produces more output. Five (5) is currently the maximum output
level.
-f Run zgvrpd in foreground. Default is to run it in
background.
-h <hostname>
Connect to remote host <hostname>.
-p <ppa>
Start zgvrpd on switch <ppa>. Default is 0.
-t <target>
Enable GVRP on the set of ports specified by the target zhp
interface. There is no default. A target must be specified.
EXAMPLES
In the following example, zgvrpd starts a background task that enables the GVRP protocol for
the ports in the zhp0 interface. zgvrpd receives and sends GVRP packets, and updates the
VLAN configuration accordingly. This background task continues throughout the life of the
Layer 2 network, or until manually terminated.
zgvrpd –t zhp0
Once you run zgvrpd, use zconfig -a to display the current VLAN configuration.
SEE ALSO
zconfig, zsnoopd
Ethernet Switch Blade User's Guide release 3.2.2j page 301