Znyx Networks bh5700 - Manual (Page 267)

vrrpconfig
NAME
vrrpconfig – Configure and control the running vrrpd
SYNOPSIS
vrrpconfig [-d <level>] -- <vrrpd parameters>
vrrpconfig [-d <level>] [-k] [-a] [-p] [-s <vid>]
DESCRIPTION
vrrpconfig provides communication with a running vrrpd daemon. The -- option for
vrrpconfig will pass all parameters to vrrpd as would be done when starting the vrrpd.
Any output generated by vrrpd is displayed on the vrrpconfig controlling tty. Any action
normally taken by vrrpd for the given parameter is done so by vrrpd. Reference vrrpd for
vrrpd parameters and their usage.
OPTIONS
vrrpconfig also has a set of local options that are not passed to vrrpd directly. Many do,
however, retrieve information from the running vrrpd. The local options are as follows:
-d <level> Set the debug level. The default debug level is 1.
The higher the level, the more debugging output is produced.
Debugging output is sent to the controlling tty. This debugging
output is from vrrpconfig. To set the debug level of vrrpd, one
would use the vrrpd debug level setting option placed after the
-- in the vrrpconfig command line.
-a Display in a user readable format, information about the
current state of all the Virtual Routers controlled by vrrpd.
-k Kill vrrpd. The entire daemon is killed. Running this
command will require that vrrpd be restarted.
-p Display relevant SNMP table values.
-s <vid> Print a numeric representation of the state of the
Virtual Router associated with the Virtual Router Identifier
<vid>. The numeric representations are 1 = INIT, 2 = BACKUP, and
3 = MASTER
Ethernet Switch Blade User's Guide release 3.2.2j page 267