Znyx Networks bh5700 - Manual (Page 167)

10hd – Ethernet Half Duplex
Pause: Enable: a port that can temporarily suspend the data transmission
between two network devices in the event that one of the devices becomes
congested. Pause enabled devices can reduce bottlenecks by making the
network more efficient.
Disabled: The pause feature is not enabled and will continue to
transmit traffic when even when the receiving device is
busy.
Faults: Internal: An internal fault indicates a severe hardware failure
External: An external fault indicates that a port has been configured to active,
but a link has not been established.
OK: ON: Indicates that the Ethernet Switch Blade has successfully loaded
OpenArchitect.
Querying Base Interface ekey Status
Link Status for a single port
To query a link status for a single port type zre<x> query for example:
zlc zre13 query
Example Output:
Link Status for a range of ports
To query the link status for a range of ports type
zre<x>..<x> query
for
example:
zlc zre0..23 query
Example Output:
Ethernet Switch Blade User's Guide release 3.2.2j page 167
sh-2.04# zlc 13 query
zre13: <UP, 100FD, PAUSE ENABLE OFF, OK ON>
sh-2.04#