Zenith Data Systems MT2000 - Manual (Page 102)

5-14
Upgrades and Options
8. Locate the DC to DC converter board. The board
connector is keyed so it can only be inserted one
way. Position the board over the socket on the board
(Figure 5-4, F) and press down evenly on the board
until it seats correctly.
9. Record the processor in the equipment log.
10. Install the processor/memory board back into the
system as described later in this chapter.
Remo vi n g a P ro cesso r
Refer to Figure 5-4 while performing the following
procedures. To remove an Pentium processor:
1. Remove the processor/memory board as described
earlier in this section.
Notice: Observe static precautions. Use an antistatic
wrist strap.
2. Push on the heatsink retention clips to release the
clips from the tabs on the ZIF socket.
3. Raise the lever on ZIF socket to the up position
(Figure 5-4, A).
4. Grasp the opposite sides of the processor, apply
equal upward force on each side and rock it from
side to side until it releases.
5. Place microprocessor and heatsink in an antistatic
package.
6. Push the lever on the ZIF socket down until it snaps
into the locked position (Figure 5-4, G).
7. Install the processor/memory board back into the
system as described later in this chapter.