Zenith Data Systems MT2000 - Manual (Page 75)

4-22
Configuring Your System
Using the SCSISelect Utility
To run the SCSISelect Utility, perform the following
procedure:
1. Insert the bootable Utilities diskette into floppy
disk drive A.
2. Power-on the system. The system boots up.
3. The MS-DOS Startup Menu displays. See Table 4-6.
4. Select 2. Execute AIC-78xx SCSISelect Utility from
the MS-DOS Startup Menu. The SCSISelect Utility
starts. When SCSISelect detects more than one AIC-
78xx host adaptors, it displays a selection menu
listing the bus and device number of each adapter.
When the selection menu appears, select the
channel you wish to configure as follows:
Bus : Device Selected SCSI Adapter
00 : 08h AIC7880
01 : 06h AIC7860
5. Once you select the adapter, the following screen is
displayed:
SCREEN DESCRIPTION
Configure/View Host Adapter
Settings Configure host adapter
and device settings.
SCSI Disk Utilities The utility scans the SCSI
bus for SCSI devices,
reports a description of
each device. Run these
utilities before configuring
SCSI devices.
6. If you wish to format a disk, verify disk media, or
display a list of devices and their SCSI IDs, select
“SCSI Disk Utilities”. If you wish to configure the
adapter or a device, select “Configure/View Host
Adapter Settings”.