Zenith Data Systems MT2000 - Manual (Page 38)

2-24
Features
Power System
The system may be configured with one or two 330
Watt power supplies. Each supply automatically
switches between these input voltage ranges:
■ 100-120 VAC at 50/60 Hz; 10 A maximum current
■ 200-240 VAC at 50/60 Hz; 5 A maximum current
■ The AC input connector is a panel mounted, IEC
320/C20 type connector.
Each supply has the following:
■ Two cooling fans integral with each power supply
enclosure. The fan circuitry implements fan failure
detection.
■ Two indicators: power and alarm.
Number of Power Supplies in a Configuration
In a system, power is drawn equally from all supplies
present (one or two power supplies). A system with one
power supply can be fully loaded (all drive bays and
add-in board slots filled). In a high-access system with
two power supplies, the second supply gives
redundancy, because the load is redistributed if one
supply fails.
Server Security
The following subsections describe mechanical locks
and software locks via the BIOS Setup.