Zenith Data Systems MT2000 - Manual (Page 98)

5-10
Upgrades and Options
To remove the board support panel:
1. Observe the safety and ESD precautions listed at the
beginning of this chapter.
2. Remove the left side panel (as viewed from front).
3. Remove four screws from the board support panel
(Figure 5-3). Save the screws for reattaching the
board support panel.
4. Remove panel by pulling it out of the chassis. Set
the board support panel aside.
Figure 5-3. Removing Board Support Panel
POWER
STATUS
DISK
B
A
Removing board support panel
A Support panel
B Screws (four total)
(structural details of panel not
shown here)
Installing the Board Support Panel
1. Place the board support panel in position so that the
rear edge of the processor/memory board fits snug
against the panel (Figure 5-3).
2. Secure the internal panel with four screws.
3. Reinstall the exterior side cover.